How to Generate Automated Transmission Motor

Commencing an Automated Transmission engine

one) Begin the engine in the Park (P) position or Neutral (N) position. The engine will not start in any other position.

2) After starting up the engine, completely depress the foot brake pedal right before shifting the selector lever from P (Park) to R (Reverse), D (Generate), three (3rd gear), 2 (2nd gear) or one (Low gear).

three) Preserve the foot brake pedal depressed and press the selector lever button to shift into a driving gear.

4) Release the parking brake and foot brake, and then step by step start the vehicle in motion by pressing the accelerator pedal.

Usually automatic transmission is designed so that the foot brake pedal Must be depressed right before shifting from P (Park) to any generate position though the ignition change is ON. The selector lever are not able to be moved out of P (Park) and into any of the other gear positions if the ignition change is turned to the LOCK, OFF or ACC position, or if the important is eliminated.

Shifting Automated Transmission

When shifting the lever into P (Park), R (Reverse) or from D (Generate) to three (3rd gear) the button situated on the lever will have to be push. Other than on the position described higher than you can shift on other position with no pressing the button on the selector lever.

P (Park)

When starting up or parking the car, the site of the selector lever will have to be in this position. Make positive that the car is completely stopped, right before shifting the selector lever into P (Park) position. As a security steps depressed the brake right before shifting the selector lever into P (Park) position. Even so, though the lever is in P position you will have to also have interaction the parking brake.

When parking on hills, depressed the brake pedal and apply the parking brake, and then shift to into P (Park) position.

R (Reverse)

Pick out the R position when you reverse your car. Prior to shifting to R (Reverse) position, guarantee that the car is completely stopped.

N (Neutral)

The engine can be began on this position. When your car is stalled though driving, you can shift to N (Neutral) position then restart the engine.

D (Generate)

This position is use for all typical driving.

three (3rd gear)

This position is improved for driving up and down slopes that want engine braking.

2 (2nd gear)

This position is use for driving uphill or engine braking for downhill.

one (Low gear):

This position is use when driving bit by bit on steep hills, driving via deep snow, sand or mud, or when earning engine brake though driving on steep down hills.

Overdrive change

Each and every time your vehicle is began, the transmission is immediately “reset” to overdrive ON.

ON: With the engine operating and the shift selector lever in the D (Generate) position, the transmission upshifts into Overdrive as vehicle speed will increase. Overdrive does not have interaction until eventually the engine has arrived at functioning temperature.

OFF: For driving up and down very long slopes exactly where engine braking is necessary press the Overdrive change as soon as. The O/D OFF indicator light-weight in the instrument panel arrives on at this time.

When cruising at a minimal speed or climbing a mild slope, you could experience unpleasant shift shocks as the transmission shifts into and out of Overdrive frequently. In this case, depress the

Overdrive change to change the Overdrive off. The O/D OFF indicator light-weight in the instrument panel arrives on at this time.

When driving conditions adjust, depress the Overdrive change to change the Overdrive on. Don’t forget not to generate at significant speeds for extended intervals of time with the Overdrive off. This reduces fuel financial system.

Shift lock release

If the battery is discharged, the selector lever are not able to be moved from the P (Park) position even with the brake pedal depressed and the ignition change in the ON position.

To move the selector lever, press the shift lock button then move the selector lever to N (Neutral) position.